To send a ColorFlash or ColorBurst for Calibration Servicing, please use the following instructions:
1. Disconnect your ColorFlash or ColorBurst from the Stimulator port of the Control Unit or E3 Console.
2. Place the stimulator into an appropriately sized box, using bubble wrap.
3. If you are within the United States or Canada, please ship to:
Diagnosys LLC
55 Technology Dr. Suite 100
Lowell, MA 01851
Attn: S-# <-- this is your RMA #
Otherwise, coordinate with your local representative.
Comments
0 comments
Please sign in to leave a comment.